CFS General Sales

SC Foundation Coating 50Lb

Manufacturer: SpecChem

Model: Foundation Coating

Quantity:

Additional Information

Application
Surface Preparation: Ensure the surface is structurally sound, clean, and free of dirt, release agents, efflorescence, curing compounds, laitance, and other contaminants. Remove form marks and other protrusions to prevent show through. Repair surface defects, including cracks and voids, using SC Foundation Coating mixed to a mortar consistency. Cut back wires by at least 3/4 and repair with SpecPatch or SpecPlug. Pre-dampen the surface with clean water immediately before applying SC Foundation Coating.
Mixing: SC Foundation Coating must be mixed mechanically using a slow-speed mixer to thoroughly disperse the ingredients for about three minutes, avoiding over-mixing.
Start by pouring approximately half of the required two gallons of liquid into a clean container and begin mixing at a slow speed.
Gradually add SC Foundation Coating and an admixture (water or Acrylic Bonder) as needed to achieve a heavy, pancake batter consistency.
Allow the mixture to fatten for ten minutes, then remix and adjust the consistency as necessary.
Application Techniques:
Hand Brush: Apply with a six-inch cement mason s brush using long, smooth horizontal strokes. Ensure sufficient material is applied to fill voids, with final strokes in one direction to produce an even texture and finish.
Push Broom: Dip a Tampico bristle push broom into the product mix and apply using long, even strokes. Ensure to fill all voids, lifting the brush at the end of each stroke.
Spray: Utilize heavy-duty spray equipment capable of handling cement-based products.
Trowel: Necessary for severe water pressure conditions, ensuring a consistent application.

* Prices are subject to change.

* Please call us for any questions on our sc foundation coating 50lb in Pasco WA, Kennewick WA, Richland WA, La Grande OR, Pendleton, and Baker City OR.